Table of Contents
Advertisement
Programming your telephone
Direct answer
If the handset is set at "Direct" answering, you can answer incoming calls automatically
by simply taking the handset out of the charging base. You need not press the Call key.
Returning the handset to the charging base always causes a connection to be ended
unless this was already done by pressing the Call key.
Mobile
M
¥
Switching handset (terminal) ON/OFF
Switching OFF
Notes
•
You can also switch off the handset with a "Long click" (at least 2 seconds) of the 0
(zero) key.
•
If you are outside the range for radiocommunications, the handset will make repeated
attempts to establish a connection with a radio base. If you plan on being out of
range for an extended period, switch off the handset to save your battery.
Switching ON
20317845en_ba_a0
Press the M-key repeatedly in programming
Answer
mode until "Mobile" appears, press the Foxkey
under "Mobile" and then under "Answer".
Ok
Press the Foxkey under "¥" to switch to "Direct:
Yes" and confirm this setting by pressing the
Foxkey under "Ok".
Press the M-key repeatedly in programming
M
mode until "Terminal" appears.
Term.
Press the Foxkey under "Terminal"; "Switch off"
will appear.
Ok
Press the Foxkey under "Ok" to switch off the
handset.
The connection to the radio base is terminated
(display is empty).
Press the Call key and switch on the set with the
Yes
Foxkey under "Yes".
35
Advertisement
Table of Contents
