Table of Contents
Advertisement
Using the extended-feature functions
Transferring a call
After initiating an enquiry call, you can connect your two callers with each other directly.
Conference
You have an enquiry call on the line and would now like to conduct a joint conference call
with your original caller (3-way).
M
Note
There is no need to worry about calls being disconnected when you set up the conference
call. The only way calls are disconnected is when the C-key or the Call key is pressed.
Call diversion
You can divert calls to another telephone or to the switchboard unit.
Div.
M
1
4
7
Note
If you only want calls to be diverted when you are busy with another call, select
"Div. on busy".
Twin Mode (present/absent)
If you have a stationary set along with your handset, Twin Mode is an easy way to make
sure you can always be reached. When Twin Mode is programmed (see "Programming
your telephone"), call diversion is automatically activated as soon as you remove the
handset from the charging base.
18
Conf.
¥
Ok
2
3
5
6
8
9
0
Press the Call key, your handset automatically
reverts to idle state.
Press the M-key and then the Foxkey under
"Conference".
Press the M-key repeatedly until "Diversion"
appears and then press the Foxkey under
"Diversion". Press the Foxkey under "¥" to select
the diversion type (i.e. "Div. on busy" or "Fwd.
to Sub.").
Dial the diversion target and if necessary the new
number.
Confirm with "Ok".
20317845en_ba_a0
Advertisement
Table of Contents
