Table of Contents
Advertisement
Before you telephone for the first time
New
GAP
GAP log-on, compatibility with other DECT products
Ascotel DECT supports all the basic telephony features as defined in the Generic Access
Profile (GAP) standard (end 1997 version). They include setting up and clearing down out-
going and incoming calls, inquiry call, DTMF and */# procedures. In other words:
•
You can log on and use your DECT system terminal on a third-party PBX. The only re-
quirement to be able to use all the basic features defined in the GAP standard is that
they are fully implemented on the relevant PBX.
•
Third-party DECT handsets that comply with the GAP standard can also be logged on
to and used on your system. However, they will provide only the functionality limited
by the GAP standard and not the same quality of radio connection. In particular the
software for Mobility Management with handover/roaming is virtually fully dependent
on the handset used and cannot be adapted 100% to your system.
Setting the PBX system
M
¥
Notes
•
With "Long Click 1" (min. 2 seconds) you can switch your handset over to the next
available PBX system (A, B, C or D). Provided the switchover is not set on "Auto",
manual switchover of the PBX system is compulsory to ensure that your handset is
ready to operate in the new PBX system.
•
"Long Click 2" is used to display the International Portable Equipment Identity (IPEI)
and PARK (Portable Access Right Key).
•
"Long Click 5" displays the software version number of the handset along with the
date.
1) See section Programming mode, page 23
20317845en_ba_a0
The handset can also be registered with a PBX
1
2
3
system from a different manufacturer by using
4
5
6
GAP (Generic Access Profile) and the required
7
8
9
0
"Authentication code.
Press the Foxkey under "New" and "GAP".
Ok
When "AC: _____" appears, enter the authenti-
cation code and acknowledge by pressing the
Foxkey under "Ok".
Press the M-key repeatedly in programming
System
1)
mode
until "System" appears. Then press
Foxkey under "System". "Auto" or the current
system (A, B, C, or D) will appear in the display.
Select the desired system or „Auto" with the
Ok
Foxkey under "¥" and confirm by pressing "Ok".
(If more than one system is available, and "Auto"
is selected the handset automatically establishes
a connection with the system that offers the best
radio connection.)
11
Advertisement
Table of Contents
