Central Pneumatic 92917 Set Up And Operating Instructions Manual page 4

i. Always assume that the tool
contains fasteners. Do not point
the tool toward yourself or anyone
whether it contains fasteners or not.
j. WARNING – Do not fire fastener on
top of another fastener. This is able
to cause the fastener to be deflected
and hit someone, or cause the tool to
react and result in a risk of injury to
persons.
k. WARNING – Remove finger from
the trigger when not driving
fasteners. Never carry the tool with
finger on trigger, the tool is able to fire
a fastener.
Tool use and care
a. Use clamps or another practical
way to secure and support the
workpiece to a stable platform.
Holding the work by hand or against
the body is unstable and can lead to
loss of control.
b. do not force the tool.
correct tool for the application. The
correct tool will do the job better and
safer at the rate for which the tool is
designed.
c. do not use the tool if the trigger
does not turn the tool on or off.
Any tool that cannot be controlled
with the trigger is dangerous and
must not be used until repaired.
d. disconnect the tool from the
air source before making
adjustments, doing tool
maintenance, clearing jams,
touching the safety nosepiece,
leaving work area, loading,
or unloading the tool. Such
Page 4 For technical questions, please call 1-800-444-3353.
e.
f.
g.
h.
Use the
i.
a.
b.
precautionary measures reduce the
risk of injury to persons.
Store the tool when it is idle out
of reach of children and other
untrained persons. A tool is
dangerous in the hands of untrained
users.
maintain the tool with care.
properly maintained tool reduces
the risk of binding and is easier to
control.
Check for misalignment or binding
of moving parts, breakage of
parts, and any other condition
that affects the tool's operation.
If damaged, have the tool serviced
before using. Many accidents are
caused by poorly maintained tools.
There is a risk of bursting if the tool is
damaged.
use only accessories that are
identified by the manufacturer for
the specific tool model. Use of an
accessory not intended for use with
the specific tool model, increases the
risk of injury to persons.
use only those fasteners listed
in the Specifications chart of this
manual. Fasteners not identified
for use with this tool by the tool
manufacturer are able to result in
a risk of injury to persons or tool
damage when used in this tool.
Service
Tool service must be performed
only by qualified repair personnel.
When servicing a tool, use only
identical replacement parts. use
only authorized parts.
A
SKU 92917
93253