Central Pneumatic 92917 Set Up And Operating Instructions Manual page 10

8. The air pressure setting must
not exceed job site regulations/
restrictions. The air pressure setting
must not exceed 90 PSI when being
used with work pieces that have a
thickness of less than 1-3/4".
9. Inspect the air connections for leaks.
Repair any leaks found.
10. If the tool will not be used at this time,
turn off and detach the air supply,
safely discharge any residual air
pressure, and release the trigger to
prevent accidental operation.
Note: Residual air pressure should not be
present after the tool is disconnected
from the air supply. However, it is a
good safety measure to attempt to
discharge the tool in a safe fashion
after disconnecting to ensure that the
tool is disconnected and unpowered.
Page 10 For technical questions, please call 1-800-444-3353. SKU 92917
93253