Listening To Audio; Disconnecting The Ipod; Recording; Recording On An External Device - Denon RCD-CX1 Owner's Manual

Listening to Audio

1
[2/u, 8/i]
Use to select the item, then press
to select the music file to be played.
2
[iPod 1/3]
Press .
Playback starts.
• If the function is set to something other than "iPod" , press
1/3] to switch the function to "iPod" and start playback. (vpage
27 "Auto Function Selector Function")
• The function can also be switched to "iPod" using
[LINE1/LINE2]
.
n Stopping playback temporarily
[iPod 1/3]
During playback, press .
Press again to resume playback.
n Fast-forwarding or fast-reversing
[CH–/8]
During playback, either press and hold
n To cue to the beginning of a track
[CH–/8] [CH+/9]
During playback, press or
n To perform Repeat/Random playback
(Browse mode only)
[REPEAT/RANDOM]
Press .
Single-track repeat All-track repeat
OFF
(indicator
Random Repeat
turns off)
n To switch between the Browse and Remote modes
[MODE]
Press .
Browse mode
Operating mode that shows iPod information on the RCD-CX1
[5/ENTER]
display.
In this mode, it is not possible to operate the iPod directly or to
perform the operations associated with the slide show function. Set
the Remote mode to play slide shows.
Remote mode
This mode is for operating the iPod directly while watching the
information displayed on the iPod's screen.
[iPod
Also see the control dock for iPod operating manual regarding
<SOURCE>
or
connection and operation.
NOTE
• DENON will accept no responsibility whatsoever for any loss of iPod
data.
• Depending on the type of iPod and the software version, some
functions may not operate.
[CH+/9]
or .
To Switch the Display
.
During playback, press
The display switches each time the button is pressed.
Title name
Random

Disconnecting the iPod

Single-track
random repeat
1
ON/STANDBY
Press
2
Remove the iPod from the control dock for iPod.
[TIME/DISPLAY]
.
Album title Artist name
Elapsed time of
currently playing track
to set the standby mode.

Recording

Recording on an External Device

First connect the device from which you want to record to the
RCD-CX1 (vpage 11).
1
<SOURCE>
Press to choose the input source to be
recorded.
2
Set the recorder to the recording mode.
b For instructions on operating, see the operating instructions of the
connected component.
3
Start playback on the player.
b For instructions on operating, see the operating instructions of the
connected component.
• The LINE2 input signal is not output to the recording output terminal
(REC).
• Adjusting the volume or tone does not affect the sound being
recorded.
ENGLISH