McAfee DR SOLOMON S ANTI-VIRUS 8.5 User Manual page 52

Installing Dr Solomon's Anti-Virus
52 Dr Solomon's Anti-Virus
• Finish your installation. Leave the Scan Memory for Viruses
before Configuring checkbox clear, then click Skip Config to finish
your installation. Setup will ask if you want to start the WinGuard
scanner and the Dr Solomon's Anti-Virus Console immediately. To
do so, select the Start Dr Solomon's Anti-Virus checkbox, then
click Finish. Your Dr Solomon's Anti-Virus is ready for use.
NOTE: If you had a previous Dr Solomon's Anti-Virus version
installed on your computer, you must restart your system in
order to start the WinGuard scanner. Setup will prompt you to
restart your system.
• Choose configuration options for your installation. You can choose
to scan your system, create an emergency disk, or update your virus
definition files before you start the WinGuard scanner and the Dr
Solomon's Anti-Virus Console.
To do so, select the Scan Memory for Viruses before Configuring
checkbox to have Setup start the Dr Solomon's Anti-Virus
application briefly to check your system memory. Next, click
Configure.
Setup will start the Dr Solomon's Anti-Virus application to examine your
system memory for viruses before it continues. If it finds an infection, it
will alert you and give you a chance to respond to the virus. To learn
about your options, see
System." If it finds nothing, the application will flash briefly as it scans
your system, then Setup will display the first of two configuration panels
(Figure 2-10).
Chapter 3, "Removing Infections From Your