McAfee DR SOLOMON S ANTI-VIRUS 8.5 User Manual page 170

Using the WinGuard Scanner
Method 1: Use the WinGuard shortcut menu
Follow these steps:
1. Right-click the WinGuard icon
2. Point to Quick Enable.
3. Choose one of the module names shown with a check mark beside it to
Method 2: Use the System Scan Status dialog box
Follow these steps:
1. Double-click the WinGuard icon
2. For each module that you want to disable, click the corresponding tab,
3. Click Close to close the dialog box.
170 Dr Solomon's Anti-Virus
its shortcut menu.
deactivate it. Module names that have a check mark beside them are
active. Those without a check mark are inactive. This method disables a
module only for the length of a scan session, or until you enable it again.
The module will start again when you restart your computer.
Depending on which combination of modules you enable, the WinGuard
icon will display a different state. To learn what each icon state means,
see "Understanding the WinGuard system tray icon states" on page
the System Scan Status dialog box
Figure 4-44. WinGuard System Scan Status dialog box
then click Disable. The same button in the property page for inactive
modules will read Enable.
Depending on which combination of modules you enable, the WinGuard
icon will display a different state. To learn what each icon state means,
see "Understanding the WinGuard system tray icon states" on page
in the Windows system tray to display
in the Windows system tray to open
(Figure 4-44).
103.
103.