McAfee DR SOLOMON S ANTI-VIRUS 8.5 User Manual page 100

Using the WinGuard Scanner
4. Select the Load WinGuard on startup checkbox at the top of the
5. Click OK to close the control panel.
Enabling the WinGuard scanner and its modules
Once you have all WinGuard components installed, you can use any of four
methods to enable them, in various combinations.
Method 1: Use the WinGuard shortcut menu
Follow these steps:
1. Right-click the WinGuard icon
2. Point to Quick Enable.
3. Choose one of the module names shown without a check mark. Module
Depending on which combination of modules you enable, the WinGuard icon
will display a different state. To learn what the different icon states mean, see
"Understanding the WinGuard system tray icon states" on page
Method 2: Use the System Scan Status dialog box
Follow these steps:
1. Double-click the WinGuard icon
100 Dr Solomon's Anti-Virus
Components property page.
NOTE: Enabling a module means activating it and loading it into your
computer's memory for use. The WinGuard scanner can start and remain
active in memory even with none of its modules enabled.
its shortcut menu.
names that have a check mark beside them are active. Those without a
check mark are inactive. If you use this method to enable a module, it
remains enabled until you restart your Dr Solomon's Anti-Virus or your
computer. At that point, its state will depend on whether you have
enabled or disabled the module in the Dr Solomon's Anti-Virus
Properties dialog box.
the System Scan Status dialog box
in the Windows system tray to display
in the Windows system tray to open
(Figure 4-1).
103.