Xerox 8400B - Phaser Color Solid Ink Printer Reference Manual page 134

Mac OS X, Versions 10.1 and 10.2
Perform these steps only for Mac OS X, versions 10.1 and 10.2:
1. Open the Network Utility, then click the Ping tab.
2. Enter your printer's IP address.
3. Click Ping. If you do not get a response, confirm that your TCP/IP settings are correct for
both your printer and computer.
4. For AppleTalk, follow the steps below. For TCP/IP proceed to Step 5.
a. From the printer's front panel, verify that EtherTalk is enabled. If it is not, enable it in
the front panel, then reset the printer.
b. Print the "Configuration Page" and verify that EtherTalk is enabled.
c.
From the "Configuration Page", verify the Zone. If you have multiple zones on your
network, verify that your printer appears in the desired zone.
5. If you are still unable to print, go to
PhaserSMART Technical Support through CentreWare Internet Services:
a. Launch your web browser.
b.
Enter your printer's IP address in the browser's Address field (http://
xxx.xxx.xxx.xxx).
c. Click Support.
d. Click the Technical Support link to access PhaserSMART.
www.xerox.com/office/support
Phaser® 8400 Color Printer
3-38
Macintosh
or access