Table of Contents
Advertisement
I. Troubleshooting
Refer to the symptoms and measures listed below before sending the camera for repairs.
Power Supply
Symptom
The power does not
Batteries are not loaded. Or they are exhausted. Load the batteries correctly. Recharge or use the
come on.
The AC Adapter is not connected correctly.
Because the camera overheated the power was
automatically turned off.
The power cuts out
The camera was left unattended and unused, so
during use.
Auto Power-Off shut it off.
Batteries are running low.
The power does not
Camera malfunction.
go off.
Cannot recharge the
Battery life.
batteries.
Batteries run out
They are being used in extreme high or low tem-
quickly.
peratures.
Many shots are being taken in dark places
inside, requiring flash.
Shooting
Symptom
Even if I press the
Batteries are not loaded. Or they are exhausted. If using alkaline batteries, replace the batteries
button, the camera
does not shoot.
The power is not on. Or the camera is not in
Shooting Mode.
The shutter button is not pressed all the way.
The Memory Card is not formatted.
The Memory Card does not have any free
space.
End of Memory Card life.
The flash is recharging.
The SD Memory Card is "locked".
The SD Memory Card's contact surfaces are
dirty.
I cannot check shot
The image confirmation time is too short.
images.
Cause
Cause
178
Measure
AC Adapter.
Reconnect it properly.
Wait until the temperature of the camera returns
to normal. Do not attempt to cool the camera
suddenly.
Turn the power back on.
If you are using alkaline batteries, replace them.
If you are using a rechargeable battery, recharge
it or use the AC Adapter.
Reload batteries.
If using the AC Adapter, reconnect it.
Replace the batteries with a new set.
-
-
Measure
with a new set. If using rechargeable batteries,
recharge or use the AC Adapter.
Turn the power on and turn the Mode Dial to
Shooting Mode.
Press the shutter button all the way.
Format the card.
Load a new card, or delete unwanted files.
Load a new Memory Card.
Wait until the flash lamp stops blinking.
Release the "Lock (write-protection)".
Wipe off with a soft, dry cloth.
Lengthen the image confirmation time.
Page
P.12
P.14
P.15
P.15
-
P.17
P.116
P.12
P.14
P.15
P.12
P.14
P.15
P.14
-
-
Page
P.12
P.14
P.15
P.11
P.38
P.112
P.18
P.95
P.18
P.52
P.18
-
P.115
Advertisement
Table of Contents
