Changing The Operation Sound Setting (Beep Sound); Changing Image Confirmation Time (Lcd Con- Firm.) - Rollei DR5100 Operation Manual

Changing the Operation
Sound Setting (BEEP
SOUND)
During operation, the camera generates four
types of sounds: start sound, shutter release
sound, focus sound, and beep sound.
Start sound : Sound when the camera power is turned
on.
Shutter release : When the shutter release button is
sound pressed, the camera generates the shut-
ter sound ('click' sound for still image
shooting and 'blip' sound for SCONT/
MCONT shooting).
Focus sound : When the focus is set, the camera gener-
ates the focus sound (blip-blip).
Beep sound : If an impossible operation is attempted,
the camera generates the beep sound
(blip-blip-blip-blip-blip).
You can change the setting to mute these
operation sounds.
Possible Settings
SHUTTER (Shutter and beep sounds only)
ON (all sounds on) *Initial setting at purchase
OFF (all sounds off)
To change the setting of operation sound, fol-
low the steps below.
1.
Turn the Mode Dial to 1
(Setup Mode).
The Setup Screen appears.
2.
Press the " " " " button to select
[BEEP SOUND].
3.
Press the #$ #$ buttons to select #$ #$
the desired setting.
This setting will be used until you change it.
Changing Image Confir-
mation Time (LCD CON-
FIRM.)
Immediately after pressing the shutter button,
the still image taken is displayed for a
moment so you can check it.
At purchase, Confirmation Time is set to one
second, but this can be changed.
Possible Settings
OFF (Photo not displayed for confirmation)
1 Second (Default)
2 Seconds
3 Seconds
To change Confirmation Time, follow the
steps below.
1.
2.
1 1 1
3.
115
Turn the Mode Dial to 1
(Setup Mode).
The Setup Screen appears.
Press the " " " " button to select
[LCD CONFIRM.].
Press the #$ #$ buttons to select #$ #$
the desired setting.
This setting will be used for shooting until
you change it.
7
1 1 1