Last Function Memory; Initialization Of The Microprocessor - Denon AVR-2801 Operating Instructions Manual

Recalling preset stations
• To call out out preset stations from the remote control unit.
1
SHIFT
(Remote control unit)
2
CHANNEL
(Remote control unit)
• Calling out preset stations from the main unit's panel.
1
TUNING
PRESET
(Main unit)
2
FUNCTION
(Main unit)

13 LAST FUNCTION MEMORY

• This unit is equipped with a last function memory which stores the input and output setting conditions as they were immediately before the
power is switched off.
This function eliminates the need to perform complicated resettings when the power is switched on.
• The unit is also equipped with a back-up memory. This function provides approximately one week of memory storage when the main unit's
power switch is off and with the power cord disconnected.

14 INITIALIZATION OF THE MICROPROCESSOR

When the indication of the display is not normal or when the operation of the unit does not shows the reasonable result, the initialization of the
microprocessor is required by the following procedure.
1
Switch off the unit and remove the AC cord from the wall
outlet.
2
Hold the following A button and B button, and plug the AC
cord into the outlet.
3
Check that the entire display is flashing with an interval of
about 1 second, and release your fingers from the 2 buttons
and the microprocessor will be initialized.
NOTES:
• If step 3 does not work, start over from step 1.
• If the microprocessor has been reset, all the button settings are
reset to the default values (the values set upon shipment from
the factory).
Watching the display, press the
SHIFT button to select the preset
memory block.
Watching the display, press the
PRESET UP or DOWN button to
select the desired preset channel.
Press the TUNING PRESET button.
Turn the FUNCTION knob and
select the desired station.
RC-881
START LEARNED/TX
SYSTEM CALL POWER
SET CALL OFF ON / SOURCE
DVD VDP TUNER SHIFT
1 2 3
TV/DBS PHONO
4 5 6
VCR-1 CD CDR / TAPE CHANNEL
7 8 9
VCR-2/V.AUX
TV/VCR
+10 0
A / B
VOLUME DISC SKIP+
DOLBY / DTS
SPEAKER SURROUND DIRECT
DSP SIMULATION 5CH STEREO STEREO
MASTER VOL.
INPUT MODE ANALOG EXT.IN
DECK CDR/MD
AUDIO CD MUTING
AVR/AVC VIDEO DVD TV
VDP VCR
SYSTEM SURROUND
TUNING SETUP PARAMETER
TITLE MENU/GUIDE
BAND
CH SELECT
ENTER
MODE
SELECT
MEMORY STATUS ON SCREEN
DISPLAY RETURN
USE/LEARN T.TONE SET UP
B
REMOTE
SIGNAL
SENSOR
LOCK DIGITAL
INPUT
STAND BY AUTO DIGITAL PCM
2
ENGLISH
1
2
VOLUME LEVEL
47