Denon AVR-2801 Operating Instructions Manual page 34

ENGLISH
[2] Listening over headphones
1 Connect the headphones to the
PHONES jack of the front panel.
2 Press the SPEAKER A or B to turn the
speaker off.
• The output to the speaker and pre-out
jacks is turned off and no sound is
produced from the speakers.
[3] Turning the sound off temporarily (muting)
1 Use this to turn off the audio output
temporarily.
Press the MUTING button.
Cancelling MUTING mode.
*
Press the MUTING button again.
[4] Combining the currently playing sound with the desired image
1 Simulcast playback
Use this switch to monitor a video
source other than the audio source.
Press the VIDEO SELECT button
repeatedly until the desired source
appears on the display.
Cancelling simulcast playback.
*
• Select "SOURCE" using the video select button.
• Switch the program source to the component connected to
the video input.
[5] Checking the currently playing program source, etc.
1 On screen display
• Each time an operation is performed,
a description of that operation
appears on the display connected to
the unit's VIDEO MONITOR OUT
jack. Also, the unit's operating status
can be checked during playback by
pressing the remote control unit's ON
SCREEN button.
Such information as the position of
the input selector and the surround
parameter settings is output in
sequence.
Front panel display
• Descriptions of the unit's
operations are also displayed
on the front panel display. In
addition, the display can be
switched to check the unit's
operating status
playing a source by pressing
the STATUS button.
34
PHONES
1
(Main unit)
MUTING
(Remote control unit)
VIDEO SELECT
(Main unit)
ON SCREEN
RETURN
(Remote control unit)
STATUS
STATUS
DISPLAY
(Main unit) (Remote control unit)
while
NOTE:
To prevent hearing loss, do not raise the volume level excessively
when using headphones.
DOLBY / DTS
SPEAKER SURROUND
DSP SIMULATION 5CH STEREO
INPUT MODE ANALOG
DECK
AUDIO CD
AVR/AVC VIDEO DVD
VDP VCR
SYSTEM SURROUND
TUNING SETUP PARAMETER
TITLE MENU/GUIDE
BAND
CH SELECT
ENTER
MODE
SELECT
1
MEMORY STATUS ON SCREEN
DISPLAY RETURN
USE/LEARN T.TONE DVD
1
SET UP
Using the dimmer function
• Use this to change the brightness of the display.
The display brightness changes in four steps
(bright, medium, dim and off) by pressing the
remote control unit's DIMMER button repeatedly.
* The brightness changes in 3 steps each time the
button is pressed, and finally the display turns off.
DIRECT
STEREO
MASTER VOL.
EXT.IN
CDR/MD
MUTING 1
TV
DIMMER
(Main unit)