Basic Operation; Playing The Input Source - Denon AVR-1507 Operating Instructions Manual

ENGLISH
INPUT MODE
INPUT SELECTOR <ANALOG>
<PHONES> <EXT. IN>
<SPEAKER>
INPUT SELECTOR
[DIMMER]
INPUT SELECTOR
About the button names in this explanation
< > : Buttons on the main unit
[ ] : Buttons on the remote control unit
Button name only :
Buttons on the main unit and remote control unit

Basic Operation

VOLUME

Playing the input source

1
INPUT SELECTOR
Use
want to play.
2
Press
SURROUND PARAMETER
Press < ANALOG > to select "ANALOG", < EXT. IN > to select "EXT.
IN".
AUTO (All auto mode):
The type of input signal is detected and the AVR-1507's surround
mode is switched automatically. Can be selected for sources for
which the Digital In Assignment mode (
The mode switches automatically to DTS/ Dolby Digital/ PCM.
The input switches to the analog input terminals is no digital
VOLUME
signals are being input.
• The INPUT mode indicator lights.
[MUTING]
PCM (exclusive PCM signal playback mode) and
DTS (exclusive DTS signal playback mode):
[STATUS]
Played when the various signals are input. Noise may be
generated when a mode different from the input signal is set.
• The INPUT mode indicator lights.
ANALOG (exclusive analog audio signal playback mode) and
EXT. IN (External decoder input terminal selection mode):
The signals input to the various input terminals are played.
To lower the subwoofer channel level in the EXT. IN mode, press
SURROUND PARAMETER and select "SW. ATT".
For some players the playback level of the SW channel may
seen strong. If so, set to "ON".
3 Start playback on the selected component.
SURROUND
PARAMETER
For operating instructions, refer to the component's manual.
INPUT MODE
to select the input source you
INPUT MODE
.
AUTO PCM DTS
EXT. IN ANALOG
page 38) is made.
18
ENGLISH
4
VOLUME
Use to adjust the volume.
• The volume level is displayed on the master volume level
display.
The volume can be adjusted between the range of –80 ~ 0 ~ 18
dB. Depending on the channel level settings and the different
surround mode settings and when in the down-mix mode, it may
not be possible to adjust the volume to 18 dB.
• Canceling the EXT. IN mode:
Press INPUT MODE or < ANALOG > to switch to the desired input
mode.
• To use the EXT. IN mode together with a picture, select the input
source to which the video signal is connected first, then set the
input mode.
• The "DIGITAL" indicator lights when digital signals are being input
properly. If the "DIGITAL" indicator does not light, check whether
the Digital In Assignment mode ( page 38) and connections are
correct.
NOTE:
• When the input mode is set to the external input (EXT. IN), the
surround mode cannot be set.
• In play modes other than the external input mode, the signals
connected to these terminals cannot be played.
Cautions when playing DTS sources:
• For DTS sources, be sure to connect the device to the digital
input terminal and set "AUTO" or "DTS" for the input source.
Noise will be generated if you play in the "ANALOG" or "PCM"
mode.
• When playing DTS signals in the "AUTO" mode, noise may be
generated when you first start playing and during searching. If so,
play in the "DTS" mode.