Setting The Test Tone - Denon AVR-1507 Operating Instructions Manual

Advanced Setup – Part 2

Setting the Test Tone

Set the volume of the various speakers so that the sound output from
the speakers and the subwoofer seems to have the same volume
level.
1 F F
Press to select "Yes".
2
F F G G H H
Press to set, then press .
Auto:
Adjust the level while listening to the test tones produced
automatically from each speaker.
Test tones are automatically emitted from each speaker.
Manual:
Adjust with the speaker from which the test tone is output
switched manually.
3
When "Auto" mode is selected:
F F G G
Press to adjust the volume.
-1
• Test tones are output automatically, in the order shown below.
FL C FR SR
(2 speakers)
SW SL SBL SBR
SB
The volume can be adjusted within the range –12 dB to +12 dB.
3
When "Manual" mode is selected:
D D H H
Press to select the speaker, then press
-2
adjust the volume.
4
ENTER
Press to finish the Test Tone setting.
5
ENTER
Press the setting and switch to the Input Setup.
1
1 7 T . T O N E
2
T . T o n e
3
• To adjust the channel level separately for the different play modes
after setting the channel level, perform the operation on page 29.
¢ Adjusting the test tone using the remote control
unit
Adjustment of the test tones using the remote control unit is only
possible in the "Auto" mode and only valid in the STANDARD (Dolby/
DTS Surround) mode. The adjusted levels are automatically stored for
the different surround modes.
(1 speaker)
1
[TEST TONE]
Press
• Test tones are output from the different speakers.
2 F F G G
Press to adjust the volume.
F F G G
to
3
[TEST TONE]
Press
Y e s <
A u t o >
T E S T T O N E O N
A U T O - F L
5
.
.
43
ENGLISH
ENGLISH
Advanced Setup – Part 2