Viewing The Embedded Web Server - HP 300X - JetDirect Print Server Administrator's Manual

Viewing the Embedded Web Server

Before you can use the embedded web server, the HP Jetdirect print
server must be configured with an IP address.
There are many ways to configure an IP address on the print server.
For example, you can automatically configure IP parameters over
the network using BOOTP (Bootstrap Protocol) or DHCP (Dynamic
Host Configuration Protocol) each time the printer is turned on. Or,
you can manually configure IP parameters using the printer's
control panel (for selected printers), Telnet, HP Web Jetadmin or
other management software.
If the HP Jetdirect print server does not receive its IP configuration
within two minutes, a default IP address is automatically assigned:
192.0.0.192. This address is not a valid IP address for your network
but can be used to initially access the HP Jetdirect print server.
However, to use the default IP address, you must temporarily set
up your system with the same IP network number or establish a
route to it.
After an IP address is established on the print server, perform the
following steps:
1. Run a supported version of your web browser.
2. Enter the IP address of the print server as the URL.
Figure B.2 Entering the IP Address
The HP Jetdirect main web page will be displayed.
Click the "?" icon on the web page for more information.
94 Using the Embedded Web Server
ENWW