HP 300X - JetDirect Print Server Administrator's Manual page 83

Table 7.6 TCP/IP Configuration Messages (2 of 2)
Message
DHCP SERVER
CONFIG FILE:
Table 7.7 Apple EtherTalk Configuration Messages (1 of 2)
Message
APPLETALK STATUS:
ETALK NET: XXXXX
NODE:XXX: X
APPLETALK NAME:
APPLETALK TYPE
ETALK ZONE:
ENWW
Description
The IP address of the system that responds to the print
server's DHCP request with configuration data. This
parameter is omitted when the print server is not
configured using DHCP.
The name of the HP Jetdirect configuration file. The file
pathname may be truncated to fit on two lines. This
parameter is omitted when the print server is configured
from the printer's control panel. NOT SPECIFIED indicates
that a file was not specified in the BOOTP reply from the
host.
Description
Current AppleTalk status.
DISABLED indicates that EtherTalk was manually
disabled. LocalTalk is always enabled.
READY indicates that the HP Jetdirect print server is
awaiting data.
INITIALIZING indicates that the print server is registering
the node address or name.
NET: identifies the AppleTalk Network Number on which
the HP Jetdirect print server is currently operating. NODE:
identifies the AppleTalk Node Number that the print server
chose for itself as part of its initialization sequence. PX
identifies the configured EtherTalk network protocol phase.
P1 is the earlier or original version of the EtherTalk
protocol. P2 is the current version of the EtherTalk protocol.
The name of the printer on the AppleTalk network. A
number after the name indicates that there are multiple
devices with this name, and this is the Nth instance of the
name.
The type of the printer being advertised on the network.
The name of the EtherTalk network zone on which the
printer is located.
HP Jetdirect Configuration Page Messages 83