HP 300X - JetDirect Print Server Administrator's Manual page 35

2. When the server responds connected to IP address, press
Enter twice to make sure that the Telnet connection is
initialized.
3. If you are prompted for a password, type the correct password.
By default, Telnet does not require a password, but you can set
up to a 14-character password by using the password command
(passwd). Once a password is set, password protection is
enabled. You can disable password protection by typing 0 (zero)
when prompted for a new password, or by performing a cold
reset on the print server.
Note
Note
Note
ENWW
Any time during the Telnet session you can type:?
then press Enter to view available configuration
parameters, the correct command format, and a list
of additional commands to display. To print current
configuration information, type / then press
Enter.
The Present Config field in the Telnet Configuration
menu describes how the HP Jetdirect print server
is configured. For example, if the HP Jetdirect print
server is configured by your BOOTP server, the
menu will contain the line, "present config=BOOTP."
Other possible configuration types are RARP,
DHCP, or Telnet/Front Panel.
On Windows systems local echo should be
selected. To determine if local echo is enabled,
perform the following:
● Run Microsoft Telnet and enter the display
command.
On UNIX systems, it is not necessary to select local
echo.
TCP/IP Configuration 35