HP 300X - JetDirect Print Server Administrator's Manual page 72

Table 7.2 General HP Jetdirect Messages (4 of 10)
Message
LAN
ERROR-CONTROLLER
CHIP
LAN ERROR-EXTERNAL
LOOPBACK
LAN ERROR-INFINITE
DEFERRAL
LAN ERROR-INTERNAL
LOOPBACK
LAN ERROR-LOSS OF
CARRIER
LAN ERROR-NO
LINKBEAT
LAN ERROR-NO SQE
LAN ERROR-RECEIVER
OFF
LAN ERROR-REMOVE
RECEIVE
LAN ERROR-RETRY
FAULTS
72 HP Jetdirect Configuration Page Messages
Description
Check the network connections. If the connections are
intact, run the power-on self-test: turn the printer off, then
on again. If the error persists, replace the HP Jetdirect
print server.
The HP Jetdirect print server is incorrectly connected to
your network or is defective. Make sure your HP Jetdirect
print server is correctly attached to your network. In
addition, check the cabling and connectors.
There is a network congestion problem. Check network
cables.
Note: If the print server is not connected to the network,
this error cannot occur.
Check all network connections.
Check the network connections. If the connections are
intact, run the power-on self-test: turn the print server off,
then on again. If the error persists, replace the
HP Jetdirect print server.
This message is displayed if Link Beat is not sensed.
Check the network cable, and verify that the
concentrator/hub is providing Link Beat.
Check the network connections. If the connections are
intact, run the power-on self-test: turn the print server off,
then on again. If the error persists, replace the
HP Jetdirect print server.
There may be a problem with your network cabling or the
HP Jetdirect print server. Check the cabling and
connectors on your Ethernet network. If you cannot find a
problem with your network cabling, run the power-on
self-test: turn the print server off, then on again. If the error
persists after the printer is turned on again, there is a
problem with the HP Jetdirect print server.
Run the power-on self-test: turn the print server off, then
on again. If this message reappears on the resulting
configuration page, you may have a problem with one of
the HP Jetdirect print servers on your network. Check all
the HP Jetdirect print servers on the network for proper
operation.
There is a problem with your network cabling or external
network configuration. Check the network cables and
connections. Verify operation of the hub or switch port.
ENWW