Unit 256 Rectangular Stud - HEIDENHAIN ITNC 530 - PILOT SMART NC Manual

Unit 256 Rectangular Stud

Parameters on the overview form:
U T: Tool number or name (switchable via soft key)
U S: Spindle speed [rpm] or cutting speed [m/min or ipm]
U F: Feed rate for plunging [mm/min], FU [mm/rev] or FZ [mm/tooth]
U
F: Feed rate for milling [mm/min] or FU [mm/rev] or FZ [mm/tooth]
U Stud length: Stud length in the reference axis
U Workpiece blank length: Blank length in the reference axis
U Stud width: Stud width in the minor axis
U
Workpiece blank width: Blank width in the reference axis
U Corner radius: Radius of the stud corner
U Depth: Final depth of the stud
U Plunging depth: Infeed per cut
U
Machining positions (see "Defining Machining Positions" on page 149)
Additional parameters on the tool detail form:
U DL: Delta length for tool T
U DR: Delta radius for tool T
U DR2: Delta radius 2 (corner radius) for tool T
U M function: Any miscellaneous function M
U Spindle: Direction of spindle rotation. As a default, smarT.NC sets M3
U
Tool preselect: If needed, this is the number of the next tool for faster
tool change (machine-dependent)
97