Opening A Dxf File - HEIDENHAIN ITNC 530 - PILOT SMART NC Manual

Opening a DXF file

The DXF converter can be started in different ways:
From the file management if you want to extract several contour or
position files consecutively
From the form during the machining definition of units 125 (contour
train), 122 (contour pocket) and 130 (contour pocket on point pattern) if
you are supposed to enter the names of the contours to be machined
While defining the machining, if you enter the machining positions via
point files
The TNC automatically saves the datum defined by you and
the current zoom condition upon exiting the DXF converter.
If you want to open the same DXF file again, the TNC loads
this information (valid for the previously selected file).
184