HEIDENHAIN ITNC 530 - PILOT SMART NC Manual page 15

U The input field Contour name is active. Create a new contour
program: smarT.NC displays a pop-up window for entering
the contour name. Enter the name of the contour, confirm
with the ENT key. smarT.NC is now in contour programming
mode
U Define the starting point of the contour in X and Y with the L
key: X=10, Y=10, save with the END key
U Approach point 2 with the L key: X=90, save with the END
key
U
Define a curvature radius of 8 mm with the RND key, save
with the END key
U Approach point 3 with the L key: Y=80, save with the END
key
U
Approach point 4 with the L key: X=90, Y=70, save with the
END key
U Approach point 5 with the L key: Y=10, save with the END
key
U
Define a chamfer of 6 mm with the CHF key, save with the
END key
U Approach end point 6 with the L key: X=10, save with the
END key
U Save contour program with the END key: smarT.NC now
again displays the form for defining contour machining
U Save entire contour machining with the END key. Definition
of contour machining is complete
U Test and run the newly created program as previously
described
15