Appendix E: Error Messages - Lexicon PCM 90 - MIDI IMPLEMENTATION DETAILS Midi Implementation Manual

Lexicon

Appendix E: Error Messages

These messages are displayed on the PCM 90 when MIDI or other errors occur.
MIDI reset complete
Receiving SysEx
data...
Transmitting MIDI
bulk data...
MIDI data dump
is complete
SysEx checksum error
SysEx data overrun
SysEx data error...
Cannot store data
as requested
Operation failed
Can't dump register
Effect unchanged
No data in dump
Effect unchanged
Need algorithm card
Bad patch data
was corrected
Displayed after a MIDI reset has been received or transmitted.
Displayed whenever SysEx data is being received by the PCM 90.
Received data must match the ID specified in the PCM 90's MIDI row
or the ID must be 127 (broadcast).
Dump is progressing. May not appear for dumps of very small data sets.
Does not appear if verbose mode is off.
Dump is over. Does not appear if verbose mode is off.
Checksum error in incoming data.
SysEx data has been transmitted to the PCM 90 faster than it can be
processed.
Indicates some sort of corruption in the SysEx data.
Usually indicates invalid Bank/offset specification. Bank may not be
writeable, or may not be present, or offset may be >49.
Catchall error message. In some store operations, may indicate that a
card is write-protected
Displayed when a bank or register which requires a card-based algo-
rithm is being dumped.
The dump just received was originally transmitted without an algorithm
card and, therefore, does not contain all necessary data. The destina-
tion of the dump is not overwritten.
The incoming dump requires an algorithm card to be decoded. The
destination of the dump is not overwritten.
A program load failed because of corrupt patch data, probably the result
of bad data in a MIDI transfer of effect data. The effect should be
carefully screened and may not be usable.
PCM 90 MIDI Implementation Details
37