NETGEAR SSL312-100NAS - ProSafe SSL312 SSL VPN Concentrator 25 User Manual page 25

• Configure Ethernet interface IP addresses
To prepare for installation:
1. Change the administrator account password.
a. On the left side of the browser window, select the Users and Groups link.
b. In the Users table, click on admin.
c. Type your new Password and re-type to Confirm Password.
d. Click Apply.
2. Configure the DNS server IP address.
a. On the left side of the browser window, select the Network link.
b. In the Network menu, click the DNS Settings radio button.
c. Enter at least one DNS server IP address.
d. Click Apply.
3. Configure a default route for Internet access.
a. On the left side of the browser window, select the Network link.
b. In the Network menu, click the Static Routes radio button.
c. Specify the Default Gateway Address.
• If you plan a single arm topology, the Default Gateway is your corporate firewall.
Specify that IP address for the ethernet-1 interface.
• If you plan a routing topology, the Default Gateway for the ethernet-1 interface is your
Internet Service Provider's gateway. The Default Gateway for the ethernet-2 interface
is your corporate firewall.
d. Click Apply.
4. Change the Ethernet port IP Addresses.
a. Select the Network link.
b. In the Network menu, click the Interfaces radio button.
c. Enter your chosen Ethernet Port 1 IP Address and Subnet Mask.
d. If you plan a single arm topology, clear the Enable Routing Mode checkbox. If you plan a
routing topology, check the Enable Routing Mode checkbox and enter your chosen
Ethernet Port 2 IP Address and Subnet Mask.
Installing the SSL312
NETGEAR ProSafe SSL VPN Concentrator 25 SSL312 Reference Manual
v2.1, November 2008
2-7