Panasonic KX-TVA594 Installation Manual page 38

2.3 Names and Locations
4.
Turn the power switch back on.
5.
Connect the port cables.
6.
Confirm that the Run Indicator blinks the same number of times as the Mode Switch position
(e.g., 5 blinks for switch position 5, etc.).
•
7.
Turn the power switch off at the VPS.
8.
Set the Mode Switch to position 0.
9.
Turn the power switch back on at the VPS.
LAN Port (Optional for KX-TVA50)
Used to access the VPS over an Ethernet network.
USB Port
Used to access the VPS via USB.
VM Link (Currently unavailable)
A VPS-PBX connection interface to be implemented in the future via software upgrade.
Ground Terminal
Must be connected to an ground source with less than 1
DC IN
Used to supply power to the VPS from the AC Adaptor.
Power Switch
Starts the system and begins the self-test.
SAFETY PRECAUTION: When making any connections or removing the cover, be sure the
power switch is turned off.
Factory Installed Flash Memory Card (KX-TVA50 only)
Stores all system programming and system prompts, and allows up to 4 hours of message recording
time.
Hard Disk Drive (KX-TVA200 only)
Stores all system programming and system prompts, and allows up to 1000 hours of message
recording time.
Note
• The actual hard disk drive mounted on your VPS may look different from the ones illustrated
in this manual.
38 Installation Manual
This may take several minutes. The Alarm Indicator and Run Indicator will first blink
intermittently before the Run Indicator blinks to indicate the Mode Switch position.
resistance.