Memory Bank Scan - Yaesu VX-8R Operating Manual

M B S
EMORY ANK
When the Memory Bank feature is engaged, the scanner sweeps only memory channels in
the current Memory Bank. However, if the Memory Bank Link Scan feature is enabled,
you may sweep the memory channels in several Memory Banks which you have selected.
To enable the Memory Bank Link Scan feature:
1. Set the radio to the Memory Recall ("MR") mode by pressing the
sary.
2. Press the
The "MR MR" indicator will be replaced by one of the Memory
MR MR MR
Bank numbers ("B 1
3. Press the key followed by the
Bank number will begin to blink.
4. Rotate the DIAL knob to select the first Memory Bank
("BANK 1 BANK 1" ~ "BANK24 BANK24") you wish to sweep using Memory
BANK 1 BANK 1 BANK24 BANK24
BANK 1 BANK24
Bank Link Scan.
5. Press the key briefly. A "B-LINK ON
pear for two seconds on the display, indicating this Memory
Bank will now be swept during Memory Bank Scan.
6. Repeat steps 4 and 5 above, to append the "B-LINK ON
notation to any other Memory Banks you wish to sweep.
7. Press the
8. Now, press and hold in the
tiate the Memory Bank Link Scan.
9. To remove a Memory Bank from the Memory Bank Link Scan, repeat steps 1 - 5
above, to change the "B-LINK ON
1) When the Memory Bank is enabled for Memory
Bank scan, the Memory Bank number ("B x") in-
dication turns into "bx" (capital "B" turns into small
"b").
2) You may enable/disable the Memory Bank scan via Set Mode
Item 7: BANK LINK.
VX-8R O
PERATING
M
EMORY
CAN
key to activate the "Memory Bank" mode.
B 1" through "B24
B 1 B 1 B24 B24
B 1 B24 B24").
B-LINK ON" notation will ap-
B-LINK ON B-LINK ON
B-LINK ON
key.
key for one second to ini-
B-LINK ON" notation into "B-LINK OFF
B-LINK ON B-LINK ON B-LINK ON
M
ANUAL
S
CANNING
key. The Memory
B-LINK ON" B-LINK ON B-LINK ON
B-LINK ON
B-LINK OFF". B-LINK OFF B-LINK OFF B-LINK OFF
S
CANNING
key, if neces-
M B S "E
EMORY ANK CAN NABLED
M B S "D
EMORY ANK CAN ISABLED
"
"
67