Tone Calling (1750 Hz) - Yaesu VX-8R Operating Manual

If the repeaters in your country require a 1750-Hz burst tone for access (typically in Eu-
rope), you can set the
configuration of this switch, we again use the Menu to help us.
1. Press and hold the
2. Rotate the DIAL knob to select Set Mode Item 61: MONI
CALL CALL
CALL CALL. CALL
3. Press the key briefly to enable adjustment of this Set
Mode Item.
4. Rotate the DIAL knob to select "T-CALL
5. Press the PTT switch briefly to save the new setting and
exit to normal operation.
To access a repeater, press and hold in the
of time specified by the repeater owner/operator. The transmitter will automatically be
activated, and a 1750-Hz audio tone will be superimposed on the carrier. Once access to
the repeater has been gained, you may release the
activating the transmitter.
VX-8R O
PERATING
CTCSS/DCS/EPCS O
T C
ONE ALLING
key to serve as a "Tone Call" switch instead. To change the
key for one second to enter the Set Mode.
T-CALL" on the display.
T-CALL T-CALL T-CALL
M
ANUAL
( 1750 H )
Z
61: MONI/T- T- T- T- T- 61: MONI 61: MONI 61: MONI
key for the amount
key, and use the PTT switch for
PERATION
45