Advanced Operation; Repeater Operation; Checking The Repeater Uplink (Input) Frequency; Tone Calling (1750 Hz) - Yaesu FTM-3207DE Operating Manual

Repeater Operation

The FTM-3207DR/DE includes the ARS (Automatic Repeater Shift) function, which per-
mits communication through repeaters automatically, by simply setting the receiver to the
repeater frequency.
1. Tune to the repeater frequency.
2. Press the PTT to transmit.
During transmission, radio waves having an 100.0 Hz* tone signal are emitted on the
frequency offset from the receive frequency by 5.0 MHz*.
*: Depends on the transceiver version.
Note: From the Setup Menu, you can change the repeater setting.
RPT ARS 34
RPT FREQ 35 à Allows changing the repeater shift frequency offset.
RPT SFT 36

Checking the Repeater Uplink (Input) Frequency

It is often helpful to be able to check the uplink (input) frequency of a repeater, to see if
the calling station is within direct ("Simplex") range.
To do this, just press the [ REV ( DW )] key. You'll
notice that the display has shifted to the repeat-
er uplink frequency. Press the [ REV ( DW )] key
again to cause operation to revert to normal
monitoring of the repeater downlink (output)
frequency. While listening on the repeater input
frequency using the [ REV ( DW )] key, the repeat-
er offset icon will blink.

Tone Calling (1750 Hz)

If your transceiver is FTM-3207DE (European version), press and hold in the program
key [ P4 ] of the microphone (MH-48) to generates a 1750 Hz burst tone to access the
European repeater. The transmitter will automatically be activated, and a 1750 Hz audio
tone will be superimposed on the carrier. Once access to the repeater has been gained,
you may release the [ P4 ] key, and use the PTT for activating the transmitter thereafter.
FTM-3207DR/DE Operating Manual
à Deactivates the ARS function.
à Allows setting the repeater shift direction.

Advanced Operation

Blinks
27