Deleting Memories; Home Channel Memory - Yaesu FT-7900R Operating Manual

M
EMORY
R
EGULAR

Deleting Memories

With 1000 "Regular" memories available (except memory channel "1 1 1 1 1 "), there frequently
are situations where you may desire to delete certain memorized frequencies. The procedure
for deleting a channel is quite simple:
1. Press the [ V/M ( MW )] key, if needed, to enter the Memory mode.
2. Press and hold in the [ V/M ( MW )] key for 1/2 second, then rotate the DIAL knob to select
the memory channel to be deleted. Note that memory channel "1 1 1 1 1 " may not be deleted.
3. Press the [ SCAN ( SEL )] key momentarily. The display will revert to memory channel
"1 1 1 1 1 ." If you rotate the DIAL knob to the location you just deleted, you will observe that it
is now invisible.
Note: Once deleted, the channel data cannot be recovered.

HOME Channel Memory

A special one-touch "HOME" channel is
available (one for each of the five operat-
ing bands), to allow quick recall of a fa-
vorite operating frequency on each band.
HOME memory storage is simple to accom-
plish:
1. Select the desired frequency, while operating in the VFO mode. Be sure to set up any
desired CTCSS or DCS tones, as well as any desired repeater offset. The power level
may also be set at this time, if you wish to store it.
2. Press and hold in the [ V/M ( MW )] key for one second. A memory number will appear
(blinking) on the display.
3. While the memory channel number is blinking, just press the [ TONE ( HM/RV )] key.
The frequency and other data (if any) will now be stored in the special HOME channel
register.
4. You may repeat this process on the other operating bands.
5. To recall the HOME channel, just press the [ V/M ( MW )] key momentarily while operat-
ing in the MR mode. From the VFO mode, press the
[ V/M ( MW )] key twice. While you are operating on the
Home channel. an "H H H H H " icon will appear on the display.
You may also append to an Alpha-numeric "Tag" to a Home channel:
1. Recall the HOME channel which you wish to append a label.
2. Press and hold in the [ BAND ( SET )] key for 1/2 second to enter the Set mode.
3. Rotate the DIAL knob to select Menu #24 (NM WRT
4. Press the [ BAND ( SET )] key twice, then rotate the DIAL
knob to select the first character in the name you wish to
36
O
PERATION
M
EMORY
C O
HANNEL PERATION
D
EFAULT
B
AND
144 MHz Ham Band 146.520 MHz 144.000 MHz
250 MHz Band
350 MHz Band
430 MHz Ham Band 446.000 MHz 430.000 MHz
850 MHz Band
NM WRT). NM WRT NM WRT
NM WRT
FT-7900R O
H C
OME HANNELS
F
REQUENCY
USA V EXP V
ERSION
250.000 MHz 250.000 MHz
350.000 MHz 350.000 MHz
850.000 MHz 850.000 MHz
M
PERATING
ERSION
ANUAL