Specifying The Time Zone - Konica Minolta bizhub 181 User Manual

Network settings
6
Use the keypad to type in the NTP server address, and then press the
[OK] key.
– If an NTP server was specified:
The date and time that data is sent with the Scan to E-Mail or Scan
to FTP operation are automatically added to the data at the same
time that the transmission date and time are recorded in the trans-
mission log.
– If an NTP server was not specified:
Only a transmission number is added to data sent with the Scan to
E-Mail or Scan to FTP operation; the transmission date and time are
not added to the data. In addition, the date and time are not record-
ed in the transmission log.
– For the NTP server address, consult with the network administrator.
The message "ACCEPTED" appears, and then the "USER SETTING"
menu appears again.
7
Press the [Reset] key.
The time is acquired from the NTP server, and then the time on the ma-
chine is set.

Specifying the time zone

1
Press the [Utility] key in the control panel.
NC-503
4
4-35