Advertisement
11. Out 2 Jack
Connect this output to a second amplifier or mixer channel for stereo
phasing. Stereo is the best way to get the most effective stereo phaser
experience from the Hyper Phase pedal.
Connections
The Hyper Phase has a single input and a pair of outputs. Out 1 is used
if the Hyper Phase is being connected to only one amplifier or mixer
channel panned center. Out 2 is used for stereo operation. Connect
Out 1 to the first amplifier or mixer channel panned left and Out 2 to
the second amplifier or mixer channel panned right.
The Hyper Phase also has built-in CIT™ cabinet modeling that can be
enabled. This is a useful tool when running a distortion pedal into the
Hyper Phase and then running direct into a mixer or recorder. CIT
creates a guitar-through-an-amplifier sound without having to use a
guitar amp.
To Enable CIT™ Cabinet Modeling:
Press the pedal down and apply power (connect a guitar cable to the
Hyper Phase input or connect the PS200R power supply to the AC
adapter jack). CIT™ cabinet modeling has to be turned on each time
you apply power to the Hyper Phase.
Advertisement
