DigiTech Artist 2120 User Manual page 61

2120 VGS Artist
However, if you plan to use the 2120 FC for continuous control over other MIDI devices (either in conjunction with the 2120 VGS or by
themselves), you need to assign a MIDI transmit channel.
To change the MIDI channels on which the selected CCs will transmit to other MIDI devices, do the following:
1. Press the <Utilities> button once. The display reads:
2. Turn the <Page> knob to page 3 and the display reads:
3. Turn the knob <4> to select the MIDI CC transmit channel. The example below uses MIDI channel 10.
4. To exit the Transmit channel assignment, press the <Program> button.
Here are a few other features that you will want to learn about to get the most out of your 2120 FC Foot controller:
Bank Up/ Tuner and Bank Down / Bypass Footswitches
These two footswitches are located at the far right side of the 2120 FC next to the Expression pedal. The Bank Up/Tuner footswitch, as you
may have guessed, will move to the next Bank Up in the 2120, as well as access the Tune Mode by simply pressing and holding the footswitch
until the Tuner appears in the display.
To access the next bank down press the footswitch once. To bypass the 2120 VGS, press and hold the footswitch until the LEDs indicate that
the unit is now in bypass mode.
User Guide
2
Output:Stereo
1 2 2 3
LINK CHANGED LINK CHANGED LINK
COMP WAH TUBE EQ GATE
FACTORY USER
1 13 DIGITAL
PAGE OF CLIP
2
MIDI: RcvChnl
1
1 2 3
LINK CHANGED LINK CHANGED LINK
COMP WAH TUBE EQ GATE
FACTORY USER
3 13 DIGITAL
PAGE OF
CLIP
2
MIDI: RcvChnl
1
1 2 3
LINK CHANGED LINK CHANGED LINK
COMP WAH TUBE EQ GATE
FACTORY USER
3 13 DIGITAL
PAGE OF
CLIP
Section - 5 The 2120 FC
Tuner
4 OFF
CHANGED LINK CHANGED
L/R OUTS
L/R OUTS
TransChnl
1
4
CHANGED LINK CHANGED
L/R OUTS
L/R OUTS
TransChnl
10
4
CHANGED LINK CHANGED
L/R OUTS
L/R OUTS
55