Installing And Removing Optional Interface Modules; Ge Xfp Interface Module - H3C LS-5500-28C-PWR-SI-OVS Installation Manual

Installation Manual
H3C S5500-SI Complete Series Ethernet Switches
Note:
When connecting a PC to a powered-on switch, you are recommended to connect the
DB-9 connector of the Console cable to the PC before connecting the RJ-45 connector
to the switch. When disconnecting a PC from a powered-on switch, you are
recommended to disconnect the DB-9 connector of the Console cable from the PC
after disconnecting the RJ-45 connector from the switch.

3.5 Installing and Removing Optional Interface Modules

The S5500-SI series (excluding S5500-20TP-SI) provide two extended module slots on
the rear panel. You can select the following extended modules:
One-port 10 GE XFP interface module
Dual-port 10 GE XFP interface module
Short-haul dual-port 10 GE CX4 interface modules

3.5.1 10 GE XFP Interface Module

I. Appearance and front panel of a one-port 10 GE XFP interface module
Figure 3-26 Appearance of a one-port 10 GE XFP interface module
Figure 3-27 Front panel of a one-port 10 GE XFP interface module
3-19
Chapter 3 Installing the Switch