Installation Of The Optional Interface Modules - H3C S3610- 28P Installation Manual

Installation Manual
H3C S3610 Series Ethernet Switches
Note:
In case the switch is powered on, when connecting a PC to the switch, first connect the
DB-9 connector of the console cable to the PC and then the RJ-45 connector to the
switch; when disconnecting them, remove the RJ-45 connector prior to the DB-9
connector.

3.4 Installation of the Optional Interface Modules

3.4.1 Installation of the Optional Interface Modules
Note：
The descriptions in this section are applicable to the installation and removal of the
interface modules on the front panel of the H3C S3610-52M and S3610-52M-DC only.
Caution:
Before performing any of the following operation, please make sure that the switch is
powered off to avoid the damage to the components.
Step 1: Wear ESD wrist strap and disconnect the power of the switch.
Step 2: Remove the blank filler panel in the module slot.
Step 3: Align the remote edge of the interface card with the hatch edge of the switch
bottom.
Step 4: Push the interface card gently into the switch until the card touches the switch
panel.
Step 5: Fix the interface card in the switch with the captive screws.
Caution:
Save the removed blank filler panel for future use.
3-14
Chapter 3 Installing the Switch