Configuring Your Camera For Ipv6 - Panasonic BL-C111A - Network Camera - Pan Operating Instructions Manual

10.3 Configuring Your Camera for IPv6

When the [Connection Mode] on the [Network (IPv6)] page is set to [Automatic Setup], an IPv6 address is
automatically assigned to the camera. To assign a static IPv6 address, follow the procedure below.
1.
Click the [Setup] tab.
2.
On the left side of the screen under [Basic], click [Network (IPv6)].
3.
Select the desired connection mode, then make the appropriate settings as described in this section.
–
[Automatic Setup]: The camera is automatically assigned an IPv6 prefix from the IPv6 router, and
produces an original IPv6 address based on the IPv6 prefix.
–
[Static]: Allows you to set all network settings manually.
[Automatic Setup]
1.
Under [DNS], enter the IP addresses of the primary and secondary DNS servers provided by your ISP.
2.
Under [Max. Bandwidth Usage], select the maximum bandwidth you want to allow the camera to use.
3.
Under [Connection Type], select the appropriate connection type.
•
Normally you can leave this setting at [Auto Negotiation].
•
BL-C131A only: If using the camera in wireless mode, [Auto Negotiation] must be selected.
4.
Click [Save].
5.
When the [New settings are saved.] message is displayed, click [Restart].
Note
•
The current network settings can be confirmed on the [Status] page (see Page 119). You can also
confirm the camera's IPv6 address using the Setup Program.
10.3 Configuring Your Camera for IPv6
Operating Instructions 133