To Access The Camera In Ipv6 - Panasonic BB-HCM331A Operating Instructions Manual

Panasonic operating instructions web camera bb-hcm331a
Table of Contents

Advertisement

Operating Instructions
1.1.1

To Access the Camera in IPv6

You need to prepare the followings to access the camera in IPv6.
PC Requirements
Operating System: Windows XP Service Pack 1
Web Browser: Internet Explorer 6.0 or later
An IPv6 Router
An IPv6 Connection Service
To connect in IPv6, subscribe to the ISP's "IPv4/IPv6 Dual-Stack" or "IPv6 over
IPv4 Tunneling" service. The camera does not work in IPv6-only network.
IPv6 Domain Name Service
In Windows XP, you cannot access the camera entering IP address on the web
browser. You need to enter IPv6 URL registered in the domain name service. We
recommend Viewnetcam.com service (see page 24 of the Installation/
Troubleshooting) as a domain name service. Ask your ISP about other IPv6
domain name service.
What is IPv6?
IPv6 is short for "Internet Protocol Version 6".
IPv6 was created to address the additional IP addresses that will be
needed as the Internet continues to expand.
IPv6 is expected to gradually replace IPv4, with the 2 coexisting for a
number of years during a transition period.
Though most ISPs (Internet Service Providers) do not yet support IPv6,
many local networks already use it. When your ISP supports IPv6, your
Panasonic Network Camera will be ready!
For more information you wish to visit http://www.ipv6.org/.
14

Advertisement

Table of Contents
loading

Table of Contents