Configuring The Camera To Use Viewnetcam.com - Panasonic BL-C111A - Network Camera - Pan Operating Instructions Manual

4.2.1 Configuring the Camera to Use Viewnetcam.com

If you are interested in accessing your camera over the Internet, we recommend using Viewnetcam.com.
Viewnetcam.com is a Dynamic DNS service designed for use with Panasonic Network Cameras. For more
information about Viewnetcam.com, please visit http://www.viewnetcam.com for details.
There are two methods you can use to configure the camera to use Viewnetcam.com.
–
Using the [Internet] tab (recommended)
To use this method, see Page 75.
–
Using the [UPnP] page
To use this method, see Page 76.
Note
•
If your router supports UPnP™ and you want to enable auto port forwarding as well as use
Viewnetcam.com, use the procedure described in Page 71.
•
If you have multiple cameras connected to the same network, only one of the cameras needs to be
registered with Viewnetcam.com. All cameras connected to the network can be accessed from the
Internet using your Viewnetcam.com URL (for example, bob.viewnetcam.com) and adding the
desired camera's port number after the URL. Example: http://bob.viewnetcam.com:50000,
http://bob.viewnetcam.com:50001, etc. Note, however, if the camera that is registered to
Viewnetcam.com is turned off and your ISP-provided global IP address changes, you will not be able
to access any of the cameras.
•
To disable Viewnetcam.com service for this camera later, access the Viewnetcam.com website (http://
www.viewnetcam.com) and cancel your registration.
•
It may take up to 30 minutes before the camera can be accessed over the Internet.
Configuring the camera to use Viewnetcam.com from the [Internet] tab
1.
Click the [Internet] tab.
2.
Under [Viewnetcam.com Registration], select [Register with Viewnetcam.com].
3.
Click [Save].
4.
When [Setup completed] is displayed, click [Go to Viewnetcam.com Registration page].
•
The Viewnetcam.com website is displayed. Follow the on-screen instructions to register with
Viewnetcam.com.
4.2.1 Configuring the Camera to Use Viewnetcam.com
Operating Instructions 75