Pioneer CLD-V2400 Programmer's Reference Manual page 28

CLD-V2400 — Front Panel View
CD CDV LD Player CLD-V2400
Power ON/OFF
Figure 2-F
CLD-V2400 — Rear Panel View
I
nterface Connector / RS-232C Por
D-SUB 15 pin. Used for serial interface connection to a
computer or a controller. See page 2-10 for details.
Function Switches
Function Switch 2 is on the left, and Switch 1 is on the right.
See Section 2.4, page 2-13 of this manual to set player functions.
INTERFACE
CONNECTOR
• •
• • • • • • • •
• • • • • • •
VIDEO OUTPUT Terminal
Jack) This terminal is connected to the video
input jack of a color video monitor.
AUDIO OUTPUT Terminals
terminals output the audio of LaserDiscs and CDs. Connect them
to the LD or AUX input terminals of your stereo amplifier. Do NOT
connect these terminals to your amplifier PHONO input.
Note:
The VHF ADAPTER OUTPUT terminals are shared with the VIDEO OUT Terminal. Therefore, either a monitor or a TV can be
connected, but not both at the same time.
Figure 2-G
CLD-V2600 / 2400 Level I & III User's Manual
CLD-V2600 / 2400 Level I & III • Chapter Two
Disc Tray Door
Barcode Terminal
Pioneer Barcode Reader or Remote Control
Unit (CU-V113 or RU-V103).
t
FUNCTION
SWITCHES
OFF
ON
Video Audio
.
1L 2R
• •
•
o
AUDIO OUT RF Adapter Output
(One RCA
(Two RCA Jacks) These
LED Indicators
Digital Sound, Disc Set, Play Standby, Key Lock
LaserDisc
for wired connection to
Power Cord
(120V AC, 60 Hz). Note: For safety reasons,
this product uses a 3-line power cord and a
3-pronged power plug. Make sure to insert
the power plug into a wall outlet with a
ground terminal.
VHF Adapter Output Terminals
the RF modulator (supplied with the unit) that is used when
connecting to a normal TV. Note that TV audio will be
monophonic when using the RF modulator. The RF
modulator uses DC 5V power supplied from the player.
When the player is powered on, player audio & video signals
are output by the RF Modulator. When the player is turned
off, the modulator will pass an external antenna signal
through to the TV.
TP 117 v. 2.0 • 12/93
Front Panel
Control
Buttons
Remote Sensor
for
receiving infrared signals
from the barcode reader or
remote control unit.
Connects to a wall outlet
These connect to
2-7