Erm Rear Panel - HP J4367A - UPS R3000 XR User Manual

Hp ups r3000 user guide
Hide thumbs Also See for J4367A - UPS R3000 XR:
Table of Contents

Advertisement

NOTE:
power is available to the load devices until utility power is restored and the UPS has been
manually powered up.
To restore power to the load devices after the REPO feature is activated, press the On button after the AC
source is reconnected to the UPS.
IMPORTANT:
battery start and the UPS assumes the load. However, if the On button is pressed and a REPO
is detected, battery start is inhibited and the UPS is not able to assume the load. The
electronics module fan spins and the General Alarm LED and an audible alarm are active as
long as the On button is held.
To power down the entire network in the event of an emergency, the REPO ports of multiple UPS units can
be connected to a single switch.

ERM rear panel

Item
1
2
3
If the UPS was operating on battery power when the remote switch was closed, no
Pressing and holding the On button without utility present normally initiates a
Description
ERM input connector (from another ERM output)
Circuit breaker
ERM output connector (to the UPS or another ERM)
Component identification 12

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

R3000j jpnR3000 naR3000h naR3000h jpnUps r3000 int

Table of Contents