Table of Contents
Advertisement
Item
Description
6
Battery Warning LED
7
Mute/Test button
IMPORTANT: While in Standby mode, the UPS maintains the charge on the batteries, but no power is
1
available at the output receptacles. The UPS remains in Standby mode until an alternate mode is selected or
until utility power is removed.
UPS R/T2200 NA/JPN/TWN rear panel
Item
Description
1
Load segment 1 (one NEMA 5-15 output receptacle for
surge and battery backup protection)
Load segment 2 (one NEMA 5-15 output receptacle for
2
surge and battery backup protection)
3
Load segment 3 (one NEMA 5-20 output receptacle for
surge and battery backup protection)
4
Load segment 4 (five unswitchable NEMA 5-15/20 output
receptacles for surge and battery backup protection)
5
Input circuit breaker
6
Input power cord with NEMA 5-20 plug
7
Serial communications port
8
USB communications port
9
REPO port
10
Voltage configuration and charge rate DIP switches
11
Power sensitivity adjustment dial
12
Ground bonding screw
Function
Red—During a self-test, the UPS found that the batteries must be
recharged. Charge the batteries and repeat the self-test
test" on page 35).
Silences UPS alarms and initiates a self-test
page 35).
("Initiating a self-
("Initiating a
self-test" on
Component identification 8
Advertisement
Table of Contents
