Programming The Homelink - Chevrolet VENTURE 2005 Owner's Manual

This device complies with RSS-210 of Industry Canada.
Operation is subject to the following two conditions:
1. This device may not cause interference.
2. This device must accept any interference received,
including interference that may cause undesired
operation of the device.
Changes and modifications to this system by other than
an authorized service facility could void authorization
to use this equipment.

Programming the HomeLink

Transmitter
Do not use the HomeLink
door opener that does not have the "stop and reverse"
feature. This includes any garage door opener model
manufactured before April 1, 1982. If you have a newer
garage door opener with rolling codes, please be
sure to follow steps 6 through 8 to complete the
programming of your HomeLink
Read the instructions completely before attempting to
®
program the HomeLink
steps involved, it may be helpful to have another person
available to assist you in programming the transmitter.
2-44
®
®
Transmitter with any garage
®
Transmitter.
Transmitter. Because of the
Keep the original transmitter for use in other vehicles as
well as for future HomeLink
recommended that upon the sale of the vehicle, the
®
programmed HomeLink
security purposes. Refer to "Erasing HomeLink
or, for assistance, contact HomeLink
www.homelink.com or by calling 1-800-355-3515.
Be sure that people and objects are clear of the garage
door or gate operator you are programming. When
programming a garage door, it is advised to park outside
of the garage.
It is recommended that a new battery be installed in
your hand-held transmitter for quicker and more
accurate transmission of the radio frequency.
Programming HomeLink
Your vehicle's engine should be turned off while
programming the transmitter. Follow these steps to
program up to three channels:
1. Press and hold down the two outside buttons,
releasing only when the indicator light begins to
flash, after 20 seconds. Do not hold down the
buttons for longer than 30 seconds and do not
repeat this step to program a second and/or third
transmitter to the remaining two HomeLink
2. Position the end of your hand-held transmitter about
1 to 3 inches (3 to 8 cm) away from the HomeLink
buttons while keeping the indicator light in view.
®
programming. It is also
buttons should be erased for
®
Buttons"
®
on the internet at:
®
®
buttons.
®