Scanner Utility - Plustek V1.2 User Manual

9. Next, go to the scanner's programme group and open the
image-editing software.
10. Select the TWAIN source from the image editing software.
11. From the FILE menu choose ACQUIRE (SCAN).
12. The TWAIN dialogue box will pop-up.
13. To scan, click the SCAN button.
14. When the scan is completed, click on CANCEL to view the
image. For more information about the TWAIN dialogue box
and its features, see Chapter IV. Using TWAIN .
Note: If the above test failed in any way, please read Appendix A:
Troubleshooting for possible solutions.

Scanner Utility

The Scanner Utility, located inside the scanner programme
group, is for determining what printer port your system has. The
only time you need to verify your system's printer port is if the
scanner does not respond when trying to scan.
To set the amount of time the scanner's light source stays on
(the factory default is approximately 7 minutes
that reads Lamp Control. Under the heading Lamp Control,
click "Turn off lamp after 5 minutes ." You can also test the
scanning lamp by clicking the Turn off Lamp, Turn on Lamp
icons.
12
), click the tab