Plustek V1.2 User Manual page 12

5. Connect the male end of the SCANNER CABLE into the
Attention:
Attention
6. Next, plug the disconnected printer cable into the rear of the
7. After plugging the scanner and printer cables into their
8. Plug the power adapter into a standard AC outlet or wall
Danger
9. Plug in all power cords and turn on your computer.
10. Install the scanner's software (see Chapter II. Software Setup
of the scanner marked HOST (see Figure 1 and step 1).
PC's printer port (see Figure 1, and step 1).
If you do not have a printer connected to your
computer and are not sure where the printer port is
located, see your computer's information book and read
the section about the printer port connector
scanner marked PRINTER (see Figure 1 and step 2).
respective locations, plug the power adapter into the
scanner's power receptor (see Figure 1 and Step 3).
branch.
Only use the power adapter that is included with your
scanner. The use of a different power adapter may
damage the unit and void your warranty
page 5).
!
4
.