Chapter I. Installing The Plustek Opticpro Scanner; Software Installation Requirements; Hardware Requirements - Plustek OPTICPRO 1248U User Manual

Chapter I. Installing the Plustek
B
efore installing your scanner, please verify that you have all of the proper
components. A list of the package contents is provided in the Box Contents section on
page 3 of this guide.

Software Installation Requirements

Your scanner comes with the image-editing software (Presto! ImageFolio), OCR
software (FineReader), document management software (Presto! PageManager), the
scanner's driver, Scanner Utility and Action Manager 32 software. All of these
software applications use approximately 160 megabytes of hard disk space after they
are installed into your computer. To ensure ample room for the installation, as well as
for scanning and saving images, a minimum of 260 megabytes of hard disk space is
recommended.
The OpticPro USB scanner can only operate under the Microsoft Windows XP,
98, Me or 2000 Professional operating system.

Hardware Requirements

This scanner connects to your computer through the Universal Serial Bus (USB)
which supports hot Plug and Play. To determine whether your computer is USB-
capable, you must check the rear of your PC to locate a USB jack that looks the same
as the one pictured below. Note that on some computers, the USB port at the rear of
the computer may be occupied and additional ports may be found on the monitor or
keyboard. If you are having trouble in locating the USB port on your computer, please
refer to the hardware manual that came with your computer.
Upon examination, you should find one or two rectangular USB ports, which
usually appear as shown below.
OpticPro Scanner
5