Table of Contents
Advertisement
Remote Control
Selects operational mode of remote
Chooses channels and enters
programming information.
Is used to enter a channel number
for multiple program channels such
as 2-1, 2-2, etc.
Turns off TV sound. Press again to
restore TV sound.
VOL (Volume) (+/-)
Changes volume.
CH (Channel) (+/-), Page Up/Down
Selects a memorized channels or
scrolls the program list in the Guide
menu page by page.
Changes the picture aspect ratio.
Arrow Buttons (3 3 / 4 4 / 1 1 / 2 2 )
Allows you to navigate on-screen
menus and to adjust the system set-
tings and preferences. Use the arrow
keys to move to a menu option and
then use the
button to access it.
Acknowledges menu selection.
Component Control Buttons
Provides control for DVD players,
VCRs, and similar components. The
SKIP buttons (. or >) are used
to jump chapter by chapter during
DVD playback. The remote control
must be programmed for the brand of
component being used. For further
instructions on remote control pro-
gramming, please refer to
pages 30-32.
Remote Control Operation Range
Point the remote control at the remote sensor and press
the buttons.
Distance: About 23 ft (7 m) from the front of the
remote sensor.
Angle: About 30° in each direction of the front of the
remote sensor.
6
MODE
control.
Numbers
Dash (-)
MUTE
RATIO
(SELECT)
(SELECT)
POWER
Turns the HD Receiver ON and OFF.
SELECT (
Acknowledges menu selection.
SIGNAL
Shows the signal strength of the
current channel. You may improve the
signal strength by adjusting the
direction of your over-the-air antenna.
HD/SD
Sets the output resolution to one of
STD (480i format) and pre-selected
HD (480p, 720p, and 1080i).
FLASHBK
Returns to the last channel viewed.
CC
Turns closed caption on and off.
MENU
Accesses or closes main menu.
AUDIO
Selects an audio language of the
program (English, French, Spanish).
SURF
Selects the list of your surf chan-
nels.
INFO
Shows station and program infor-
mation on the screen.
EXIT
Removes all on-screen displays
and returns to TV viewing from any
menu.
Remote control battery installation
Detach the battery cover on the rear of the remote con-
trol, and insert two R03 (size AA) batteries with
aligned correctly.
Caution
Do not mix old and new batteries. Never mix different
types of batteries (standard, alkaline, etc.).
)
and
Advertisement
Table of Contents
