Xerox Phaser 7760 User Manual page 70

Printing Transparencies from Tray 2
1. Pull out Tray 2.
2. Insert the transparencies into the tray and adjust the paper guides to fit the transparency
size.
Note: Do not load transparencies above the transparency fill line inside the tray.
3. Push the tray completely into the printer.
4. When the control panel prompts you to confirm the type and size of paper in the tray:
a. Select
Change setup
b. Select the
Xerox Transparency
c.
Select the transparency size, and then press the OK button.
Note: For some sizes that can be loaded in either direction, you need to select the size
with the letters
LEF
left side of the tray or
side of the tray.
5.
In the printer driver, select Transparency as the paper type and/or select Tray 2 as the
paper source.
, and then press the OK button.
, and then press the OK button.
(Long-Edge Feed) if you loaded the long edge of the paper along the
(Short-Edge Feed) if you loaded the short edge along the left
SEF
Phaser® 7760 Color Laser Printer
3-35
Printing on Specialty Media
7760-023
7760-122