Configuring Lpr; Configuring Ipp; Configuring Slp; Configuring Centreware Is - Xerox Phaser 3600 User Manual

Configuring LPR

Your printer can use LPR (Line Printer Protocol) which transmit the
printing data through port 510. To enable LPR, take the following steps:
1 Press Menu until Network appears on the bottom line of the
display and press OK.
2 Press the Up/down arrow buttons until LPR appears and press
OK.
3 Press the Up/down arrow buttons until On appears and press OK.

Configuring IPP

Your printer can use IPP ( Internet Printing Protocol) which transmit the
printing data through port 631. To enable IPP, take the following steps:
1 Press Menu until Network appears on the bottom line of the
display and press OK.
2 Press the Up/down arrow buttons until IPP appears and press OK.
3 Press the Up/down arrow buttons until On appears and press OK.

Configuring SLP

Your printer can use SLP (Service Location Protocol) which transmit the
printing information through port 427. To enable SLP, take the following
steps:
1 Press Menu until Network appears on the bottom line of the
display and press OK.
2 Press the Up/down arrow buttons until SLP appears and press
OK.
3 Press the Up/down arrow buttons until On appears and press OK.

Configuring CentreWare IS

Your printer can use CentreWare IS (Internet Services). To enable
CentreWare IS, take the following steps:
1 Press Menu until Network appears on the bottom line of the
display and press OK.
2 Press the Up/down arrow buttons until CentreWare IS appears
and press OK.
3 Press the Up/down arrow buttons until On appears and press OK.
4.4
<Network setup (Phaser 3600/N, Phaser 3600/DN only)>