Replacing The Roller Assembly - Visioneer OneTouch 9750 User Manual

138 V 9750 S U ' G
ISIONEER CANNER SER S UIDE
R R A
EPLACING THE OLLER SSEMBLY
After extended use, the roller may wear out and may need to be
replaced. It is a user-replaceable part and can be ordered. See the section,
"Visioneer 9750 Scanner Parts List" on page 148 for the part number.
Frequent paper jams are a symptom of a worn roller assembly. A worn
roller can cause documents to feed in skewed at an angle, or multiple
pages to feed at the same time. In both cases, paper jams may occur. A
worn roller should be replaced to avoid damage to the scanner's internal
parts. However, before replacing the roller you should clean it first as
excessive dust on the roller will make it appear worn and smooth to the
touch. You cannot properly diagnose a worn roller until you have
cleaned it.
To replace the roller assembly:
1. Open the ADF cover.
2. The roller is located in the ADF cover.