Visioneer OneTouch 9750 User Manual page 26

S 4: C
TEP
3. Turn on the power switch, located to the right of the power port.
The status light comes on and flashes indicating that the scanner is
receiving power.
If you are using Windows XP Service Pack 2, and have plugged the
USB cable into a USB 1.1 port, an information bubble may open
explaining that "A HI-SPEED USB device is plugged into a non-
HI-SPEED USB hub". Plug the USB cable into a USB 2.0 port (if
available) or just disregard the message. If you leave it plugged into
the USB 1.1 port, your scanner may scan a bit slower.
4. Your computer recognizes that a scanner has been plugged into the
USB port and automatically loads the appropriate software to run
the scanner.
USB C
ONNECT THE ABLE AND
T P
URN ON THE OWER
19